Friday, January 25, 2019

Windshield Snap Vents (0.5)

0.5 hours

Before installing the windshield, I wanted to install these little snap vents.  I figure it's less dangerous to cut the holes with the lexan laid out flat than under tension once installed.

These are the vents I ordered.  All they need is a 3-1/4" hole to install into.  I just used a regular 3-1/4" hole saw to do it.  I was a little worried that I'd end up with a sloppy fit, but it turned out just fine!  I placed the hole so it would be 1" away from the windshield skirt on all sides.


No comments:

Post a Comment